
8
2.3 underStandinG the Battery & ac adaPtOr icOn
Battery icon shows
power status:
FULL
HIGH
MIDDLE
LOW
Battery icon shows when the AC power supply is unplugged or interrupted.
9V battery functions as BACK-UP only and the symbol means LOW
BATTERY.
The LCD backlight flashes YELLOW for 30 seconds and will blink until
the new battery is replaced or the mains power supply (with AC adaptor) is
plugged in.
AC Adaptor icon
When the AC adaptor to the Wireless Alarm Panel is connected to a wall
socket, the AC symbol will appear.
The backlight will be ‘ON’ for 10 seconds while the AC adapter connects to
the power supply.
SECTION 3: USING THE WIRELESS ALARM SYSTEM
3.1 PrOGramminG yOur new 4-diGit Pin
The Wireless Alarm Panel is supplied with a default PIN of “1234”. This can be changed to your own
personalized PIN, or your own personalized PIN can be changed, as follows:
Keys Description Note
1
(1234 or 4-digit
PIN) +
You must be in STANDBY
mode before programming
your new 4-digit PIN
*To make sure you are in STANDBY mode:
- Enter the default PIN “ 1–2–3–4 ”
- Press
- The panel will display the image below when you are in
STANDBY mode:
(One beep indicates that you entered a valid PIN, three
beeps indicate that an invalid operation was performed).
2
(1234 or 4-digit
PIN) +
Enter the default PIN “ 1–2–3-4”
OR your new 4-digit PIN
followed by
The panel will display the below image:
3
Press followed by
- Press then “1” to set the new PIN
- The panel will display the below image :
4
New 4-digit PIN
+
Enter the new 4-digit PIN
followed by
- LCD display flashes with “1”
- Enter the new 4-digit PIN
- Press
to confirm
5
New 4-digit PIN
+
Re-enter new PIN for
followed by for final
confirmation
- LCD display
flashes with “2”
- Re-enter the new 4-digit PIN
- Press
for final confirmation
(One beep indicates that you entered a valid PIN, two
beeps indicate that an invalid operation was performed).
Comentarios a estos manuales