Mace MAS-WA-SYS Guía de usuario descargar pdf (Pagina 15)

3.3.4 hOme mOde

There are default settings that allow the system to operate after opening the package. These settings

can be adjusted to suit your individual requirements The HOME mode allows the system operate in

both the ARM and ALERT modes in different zones.

HOME mode default setting:

Sensor Zone Status (MODE)

• Door/Window Sensor 1

ALERT

• Door/Window Sensor 2

ALERT

• Motion Sensor 8

ARM

a. enterinG the hOme mOde

• On the Keychain Remote Control: Press to activate.

• On the Wireless Alarm Panel: First make sure the panel is in STAN DBY mode, and then enter HOME

mode by taking the following steps:

Keys Description Note

(1234 or 4-digit

PIN) +

You must be in STANDBY

mode before turning to

HOME mode

*To make sure you are in STANDBY mode:

- Enter the default PIN “ 1–2–3–4 ” OR your new 4-digit PIN

- Press

- The panel will display the below image while you are in

STANDBY mode:

(One beep indicates that you entered a valid PIN, three beeps

indicate that an invalid operation was performed).

4-digit PIN +

Enter 4-digit PIN, press

and for HOME mode

- Then system will enter HOME mode

- If the Zone is enabled, a number will appear as displayed in the

image below:

B. exitinG the hOme mOde

• On the Wireless Alarm Panel: Enter your 4-digit PIN followed by to exit HOME mode.

• On the Keychain Remote Control: Press to exit HOME mode.

c. ZOne SettinGS

Programming each zone in HOME mode: